Vornado TVH500 Especificações descarregar pdf (Página 11)

English

 To properly carry the heater, place one hand on the back opening and use your

other hand to hold from the front.

 In smaller areas, you might prefer to set the unit in Low mode. A vortex beam of

air will gently keep the air circulating in the room for even, uniform heating.

 In larger spaces, you might prefer to set the unit in High mode. A vortex beam of

air will gently keep the air circulating in the room for even, uniform heating.

 To use the TVH 500 as a personal fan, set the mode to Fan.

 The TVH 500, like any other 1500-watt electric heater, draws up to 12.5 amps of

electric current. If using your TVH 500 on High setting causes your home circuit

breaker or fuse to trip, we offer the following suggestions:

 Try turning off other electrical appliances that run on the same circuit as your

heater.

 Run your heater in Low mode.

 Have your electrician add an additional circuit to your home’s electrical system.

 When the room temperature is higher than the set temperature it is normal and

correct to have little to no heat coming out of the TVH 500. When the unit is ﬁrst

turned on there is a slight delay before heat will start to be produced.

 ALWAYS USE COMMON SENSE WHEN USING THIS AND/OR ANY ELECTRICAL

APPLIANCE.

 Do not use more than one heater at a time.

 Never ignore or take lightly the signs of an electrical problem, such as:

 Warm outlet cover plates

 Sparking at outlet when plugging in or during operation

 Light ﬂickering or dimming (indicates a shared circuit or problem)

Investigate the cause of these before continuing to use the heater.

Problem Possible Cause and Solution

Operating Tips

Troubleshooting

Unit is not plugged in. Plug Power Cord into electrical outlet.

Household circuit breaker / ground fault interrupter has tripped or blown a fuse. Reset circuit breaker / ground fault inter-

rupter, or replace fuse (See OPERATING TIPS).

The unit has overheated. Automatic Safety Shut-Off has initiated (See RESETTING YOUR VORNADO HEATER).

Unit is damaged or in need of repair. Cease usage and unplug. Contact Consumer Service for assistance.

Ensure unit is set to High Heat and set temperature is at the highest setting.

Close all doors and windows to trap heat.

Allow the unit to fully circulate the heat throughout the room, may take several minutes.

Unit fails to power on.

Unit is not producing

sufﬁcient amount of heat.

1 2 ... 6 7 8 9 10 11 12 13 14

Sem comentários

Vornado TVH500 Especificações Página 11